Coat It Blue: Revolutionizing HVAC Corrosion Protection
Tired of costly and time-consuming HVAC maintenance?
Introducing Coat It Blue, the revolutionary corrosion protection solution that eliminates the need for disruptive disassembly and transportation.
Key Benefits:
- On-Site Application: Applied directly at your location, minimizing downtime and disruption to your business or home.
- Fast and Efficient: Reduces maintenance time and streamlines the process.
- Water-Based Technology: Safe and environmentally friendly, with low odor and NSF accreditation.
- Unmatched Corrosion Protection: Provides up to 5+ years of protection against neutral salt spray corrosion.
- Improved Efficiency: Reduces operating costs by maintaining optimal heat exchanger performance.
- Cost-Effective Solutions: Available in various sizes to suit your needs, from small touch-up aerosols to large 55-gallon drums for commercial applications.
Experience the Coat It Blue difference:
- Enhanced Convenience: Minimize downtime and disruption to your daily routine.
- Reduced Costs: Streamline maintenance and lower overall project costs.
- Superior Protection: Extend the lifespan of your HVAC equipment with unmatched corrosion resistance.
Choose Coat It Blue for a safer, more efficient, and cost-effective way to protect your HVAC investment.
Available Products:
- CIB-1-5-55 – Coat It Blue Liquid 1,5, 55 gallons
- CIC-1-5-55 – Coat It Clear Liquid 1,5,55 gallons
- CIBA-1 – Coat It Blue Aerosol (Touch up)
- CIB_SC-LC – Coat It Blue Canister, Small 10 lb, Large 30lb
- CIRA-1 – Coat It Blue Remover
- CIR-16OZ – Coat It Clear Remover Liquid
Directions for Use:
Safety Precautions:
- Wear high-density rubber gloves, full or half face masks with filters rated for pesticides and solvents, safety goggles, and a full body waterproof suit with a hood. Type 1 heavy-duty safety boots are also necessary.
- Ensure that the unit is turned off before and during application.
- Remove filtration media, and cover them with a tarpaulin or plastic sheeting if needed. Air filters are best disposed of and replaced. Other parts of the system may need to be covered as well, such as the fan motor and sensors.
- Remove any visible debris and corrosion before application. Use Vapco’s Quad Power coil cleaner for best results.
Application:
- Ensure that Coat It Blue is homogeneous by shaking it vigorously before application.
- Decant into Airless spray gun/applicator (if using liquid) — An electric airless spray gun such as a Wagner W180P, Flexio 585, an industrial unit with a variable pressure airless system or equivalent. (For spraying of micro-channel coils an Atomex HSP-10 is a better option as penetration is increased).
- Start applying from the top, spraying parallel to the coils
- Spray directly onto the coil and covering the entire surface, paying special attention to end plates and tube ends/elbows.
- Apply two spray passes for each side of the coil.
- Allow each pass to partially dry before subsequent passes. Do not over-apply on any pass.
- Maintain a uniform distance from the coil (four to six inches) to achieve effective surface coverage. Apply treatment to both sides of the coils wherever possible.
- Ensure that the product is applied to coil end plates and tube bends/ends.
- The final appearance of the cured product can vary from translucent light blue to a darker color, depending on the type, state, and condition of the aluminum fins.
Cleanup:
- Clean any over spray, equipment, etc. immediately after application with Vapco’s Coat It Clean Up.
