GOLDEN BEAR REMOVER
Powerful Adhesive Remover for Clean Spraying Systems
GOLDEN BEAR REMOVER is a specialized cleaning solution designed to maintain the efficiency and reliability of adhesive spraying systems. By preventing adhesive buildup, it helps ensure smooth and uninterrupted operation. It’s also ideal for removing improperly installed insulation and bubble wrap.
Key Features and Benefits:
- Instant Tack: Quickly and effectively removes adhesive residue.
- Flexible Bond Line: Easily penetrates and dissolves stubborn adhesive.
- Clear Formula: Allows for precise application and visibility.
- Low Soak-In: Minimizes damage to surfaces while effectively removing adhesive.
GOLDEN BEAR REMOVER is a must-have tool for professionals and DIY enthusiasts who rely on adhesive spraying systems. Its powerful cleaning action and versatility make it an essential component of any well-maintained adhesive application setup.
Part Number; Size
- GBR-SC 15 lb cylinder
DIRECTIONS:
- Shake before using, and then hold can 8-12 inches from surface.
- Keep can moving for an even coat.
- Let adhesive dry to tack and bond.
Spray one surface only for a temporary bond. Spray both surfaces for a permanent bond.
Not recommended for unsupported vinyl fabric.
Certain plastic and elastomeric substrates can have bond failure due to plastic migration. High temperature and humidity may cause bonds to fail. For nonmetallic substrates, test production parts in normal environments for compatibility.
Maintenance, Spray Gun and Hose: It is recommended to flush the hose and gun between each new cylinder of Golden Bear Adhesive Remover. This will ensure a fresh start with your new adhesive cylinder and increase the life of your hose and spray gun. Shut off cylinder valve on the used adhesive cylinder and bleed the pressure from the hose by spraying the gun into a disposable container. Remove the hose from the adhesive cylinder and attach it to the cylinder. Open adhesive valve and spray.
Clogged Hose and Spray Gun: Shut off cylinder valve on the used adhesive cylinder and bleed the pressure from the hose by spraying the gun into a disposable container. Remove the hose from the adhesive cylinder and attach it to the cylinder. Open valve. Let the system sit for 5 minutes. Stay gun into a disposable container. Repeat until clean. Shut off cylinder valve and bleed pressure from the hose by spraying the gun. Remove the hose from the cylinder and put back on the adhesive cylinder. Open adhesive valve and spray.
Clean Up Excess Adhesive: With hose and spray gun attached, spray directly onto the adhesive to be removed and wipe with a cloth. For more control, spray directly on to the cloth and then wipe away adhesive. Always wear rubber gloves and safety goggles. Wash hands after use.
DANGERS & PRECAUTIONS
Read and understand the product’s label and Safety Data Sheet. Extremely flammable gas. It contains gas under pressure. May explode if heated. Causes eye irritation. May cause drowsiness or dizziness. May be fatal if swallowed and enters airways. Keep away from heat, sparks, open flames, and hot surfaces. Leaking gas fire: Do not extinguish, unless leak can be stopped early. Eliminate all ignition sources. Protect from sunlight. Wash hands after using. Keep out of reach of children. Keep away from heat, sparks, open flames, and hot surfaces. Leaking gas fire: Do not extinguish, unless leak can be stopped safely. Eliminate all ignition sources if safe to do so. Protect from sunlight. Store in a well-ventilated place. Wash hands thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear safety glasses and chemical resistant gloves when using the product.
